Rust gone

Just like new...

Some people asked me how I cleaned all the nuts and bolts and how I made them look like new.
I think the pictures speak for itself. Normally I use the lathe in my workshop to turn the screws and a bigger wire brush with an ordinary drilling machine. But today I had to clean only seven Airloc bolts and I did it with simpler tools. The result is the same but it takes a little bit longer.
I let the screw turn at a medium speed and move the rotating brush over the surface until it shines. There's not much you could do wrong. Just don't use a too hard brush and don't use too much pressure or you will cut grooves into the surface.

And that's the whole secret :-)